Retourner

Recette: Rust

In order to create real rust on different kinds of surfaces, such as panels, canvas, and even the masonry of walls, you can use iron powder. The most suitable binders for metal powders are watery binders, such as acrylic dispersion. On smooth, absorbent surfaces, we recommend using a primer, such as Primal® WS 24 (#75250) or Primer for Grassello and Marmorino (#31942).

Traitement

On horizontal surfaces, spread or roll out the pure Acrylic Dispersion (e.g. #76000 or #75367). Pas 1: On horizontal surfaces, spread or roll out the pure Acrylic Dispersion (e.g. #76000 or #75367).
Then sprinkle the iron powder onto the sticky surface using the fine sieve. When it is dry, shake off or sweep off excess powder. Iron Filings (#54600) and Steel Powder (54650) also rust, but they rust slower than Cast-Iron or Iron Powder. These powders are very fine. Therefore, they should be mixed with acrylic dispersion prior to application, using a paint brush or roller. In order to make a trowel textured mixture, you can thicken the acrylic dispersion with the Thickener Rohagit® SD 15. Adding cellulose glue K 1000 helps the rusting process because it holds moisture. Then, you mix it with Iron Powder (#54660) until it becomes a trowel textured paste. You can further change the color of the rust layer by adding Iron Oxide Pigments (#48700). The surface must be kept moist until rust is formed. You can speed up the process by spraying the surface with a solution made up of 20 grams of common salt and 1 tablespoon of vinegar in 1 liter of water. Pas 2: Then sprinkle the iron powder onto the sticky surface using the fine sieve. When it is dry, shake off or sweep off excess powder. Iron Filings (#54600) and Steel Powder (54650) also rust, but they rust slower than Cast-Iron or Iron Powder. These powders are very fine. Therefore, they should be mixed with acrylic dispersion prior to application, using a paint brush or roller. In order to make a trowel textured mixture, you can thicken the acrylic dispersion with the Thickener Rohagit® SD 15. Adding cellulose glue K 1000 helps the rusting process because it holds moisture. Then, you mix it with Iron Powder (#54660) until it becomes a trowel textured paste. You can further change the color of the rust layer by adding Iron Oxide Pigments (#48700). The surface must be kept moist until rust is formed. You can speed up the process by spraying the surface with a solution made up of 20 grams of common salt and 1 tablespoon of vinegar in 1 liter of water.

Ingredients

Fonte grise (#54610)
Poudre d´acier (#54650)
Alternative:
Fer-neuf en poudre (#54660)
Dispersion K 9 (#75367)
Alternative:
Dispersion K 498 (#76000)
Tamis
si besoin est Épaississant K 15 (#76910)
si besoin est Tylose® MH 1000 P2 (#63610)

Remarque

Warning: When handling or storing metal powders, special safety precautions should be taken: Wear respiratory, eye and clothing protection and use gloves!

Nous déclinons toute responsabilité pour le résultat de l´application des processus décrits ici. Dans tous les cas, nous recommandons de réaliser des tests avant l´application définitive.

Liste de produits

Auteur: Kremer Pigmente